Products

ES Net Network Applications ES Network (ES Net) is a high bandwidth (100 Mbps) IP based fire alarm network that supports up to 99 nodes and uses in...

FFE Reflective Beam Smoke Detectors Accessories The Fireray 5000 System is an auto-aligning, self-correcting infrared reflective beam smoke detecto...

5000 System Controller Back Box, surface or flush mount

The optional cellular module can be used in cases where access to a LAN connection is not possible, or as a backup connection to give customers add...

Li-ion Tamer® GEN 3 The Li-ion Tamer GEN 3 is a device that detects the venting of battery electrolyte solvent vapours (off-gassing phase) that occ...

The 517.050.023FC 5BEX detector base has been ATEX approved for use with the series M600Ex and series 800Ex intrinsically safe detectors and is cov...

5’ Network Cable (RJ45), Gen 3

6 in. adaptor plate used with a 5 in. base Details: Required to mount to surface mounted 4 in. (102 mm) square or 4 in. octagonal boxes, and to 4 ...

End-of-Line Resistor Harnesses Six Point Module The Six Point Module allows a compatible fire alarm control unit IDNet communications channel to mo...

516.600.066FC 601FEx Infra-Red Flame Detector The 601F and 601FEx point type flame detectors form part of the 600 series of conventional detectors....

General Features: Manufactured to EN54 part 3. Integral sounder and detector base. Volume and tone adjustable after installation. Low Power Synchr...

ES Net Network Applications ES Network (ES Net) is a high bandwidth (100 Mbps) IP based fire alarm network that supports up to 99 nodes and uses in...

For use with 4100ES/4100U Fire Alarm Control Units, Remote Annunciators, and Network Display Units (NDU) 4100ES/4100U fire alarm control units supp...

Panel-Mounted Annunciation Modules for use with 4100ES/4100U Fire Alarm Control Units, Remote Annunciators, and Network Display Units (NDU) LED/Swi...

7 Ah Battery Model (Sealed lead-acid batteries, 12 VDC each)

Emergency Voice / Alarm Communications with ES Touch Screen Display Equipment Amplifier-Mounted, Constant Supervision Module 70.7VRMS Constant Supe...

The 711H is an A1R heat detector that uses both rate-of-rise and 60°C static temperature sensing, where the fixed element provides a backstop for f...

The 711P operates by sensing the optical scatter from smoke particles generated in a fire These intelligent, conventional detectors come with built...

The 701PH smoke and heat detector operates as a standard optical detector under normal ambient conditions. However, when a rapid rise in temperatur...

The 712H is an A1S heat detector with a static response temperature of 60°C (EN54-5). Since it only responds at these specific temperatures. The bu...

The 713H heat detector has a static response temperature of 90°C (EN54-5), which works best in areas where higher temperatures are normal such as e...

8 A Relay Omar's allow fire alarm control units to control a remotely located NO and NC contact using IDNet addressable communications for both dat...

Audio Controller-Mounted, Audio Memory Module 8 Minute Message Expansion Module, adds 8 minutes (Normal Resolution) or 4 minutes (High Resolution) ...

8 point zone/relay 4 in. x 5 in. flat module

8 point zone/relay 4x5” flat module

4010ES Fire Control Units, International Addressable Fire Detection and Basic Control Unit Modules and Accessories 4010ES Series Fire Detection and...

Remote Annunciator Panels LED and LED/Switch Modules, General Purpose Remote Annunciator Panels are dedicated purpose transponders that support fir...

8 VDC Converter Required for multiple Physical Bridge Modules, 3 A maximum 1 Block included with loads

8 Zone Initiating Device Circuit Class B, 75 mA, 195 mA

8 Zone Initiating Device Circuits Class A, 75 mA, 195 mA 4100-5015 Datasheet Download 4100-5015 Datasheet

Compatible with FC400 and FC460 Series detectors.

The 800F is a digital addressable, low cost infrared flame detector with some high end features such as ‘Solar Blind’ operation for false alarm fre...

The 801RIL Remote Indicator is used where a detector LED is not visible i.e., when the detector is mounted in a roof void, lift shaft etc. All dete...

The 80DSB is a detector base specifically for use with the ZETTLER addressable detectors. The base incorporates a fire alarm sounder that is activa...

Tyco 811F MX Flame Detector (Marine) The 811F and 811FEx point type flame detectors are part of the MXTechnology range of digital addressable fire ...

The engineering management tool communicates with the 850 series and 830 series devices using a 2 way infrared wireless link. Commissioning data is...